JVC HR-XV38SAG - Manual (Page 28)

Filename [XV38ASAG_057S-VHS.fm]
Masterpage:Left+
28
EN
Page 28 December 8, 2004 3:22 pm
OPERATIONS ON VHS DECK (cont.)
F
Return to the normal screen.
Press PROG or ENTER. “PROGRAM COMPLETED”
appears on the TV screen for about 5 seconds, then the
normal screen appears. If “PROGRAM OVERLAPPED”
appears on the TV screen, see page 28.
● Repeat steps B – F for each additional programme.
G
Engage the unit’s timer mode.
Press #. The unit turns off automatically and “#”
appears on the front display panel.
● To disengage the timer mode, press # again.
NOTES:
● To Change The Stop Time:
— press STOP +/– after pressing ENTER in step D. You can
compensate for anticipated programme schedule delays.
● To Timer-Record Weekly Or Daily Serials:
— after pressing ENTER in step D, press WEEKLY (number key
“9”) for weekly serials or DAILY (number key “8”) for daily
serials (Monday — Friday). Either “WEEKLY” or “DAILY”
appears on the TV screen. Pressing the button again makes the
corresponding indication disappear.
● You can programme this unit to timer-record as many as 8
programmes. If you try to programme the unit to record a
ninth, “PROGRAM FULL” appears on the TV screen and
“FULL” appears on the front display panel. To record the extra
programme, you must first cancel any unnecessary
programmes. (
੬
pg. 30)
ATTENTION
Guide Program Number Set
“G- CODE /S HOW V IEW SETUP”
appears afterperforming
step
D if the Guide Program
number for the G- CODE
number you entered has not
been set.
Press
rt or the number keys
to input the channel position
number on which your unit
receives that station, then
press
ENTER or e to set the Guide Program number. The
G- CODE Program screen appears.
G-CODE/SHOWVIEW SETUP
GUIDE PROG TV PROG
[0-9] OR [ / ]
[PROG] : EXIT
2 – –
XV38ASAG_EN_BOOK.book Page 28 Wednesday, December 8, 2004 4:00 PM