Jacuzzi Dome For Shower Surround System None - Manual (Page 17)

Troubleshooting
SYMPTOM
Overall floor surface feels cold
after system has been energized
for more than 3 hours.
Overall floor surface feels too
hot when system is energized.
Cable has been damaged.
Floor takes too long to warm up.
POSSIBLE
CAUSE
Set point of heating control
device is too low.
Heating control device not
functioning properly.
Contact Jacuzzi at 1-800-872-
7277 and request a Trouble-
shooting Kit to be sent to your
electrician to locate the damaged
section of cable.
Excessive heat loss due to non-
insulated floor or because located
above and unheated area.
CORRECTIVE
ACTION
Increase the set point of the heat-
ing control device to a comfortable
level.
Reduce set point of the heating
control device to comfortable
level.
A damaged cable can typically
be repaired by removal of only
a few tiles, splicing the cable and
replacing the tiles.
Increase the set point of the heat-
ing control device until the floor
reaches a comfortable level.
Increase the amount of insulation
below the floor where permissible.
Contact the heating control
device manufacturer.
15
For additional help contact Jacuzzi Customer Service at 1-800-872-7277.