John Lewis JLTDC06 - Manual (Page 13)

13
Using the tumble dryer
Before using your tumble dryer for the first time, we
recommend that you to place a few damp cloths
inside the appliance and dry for 30 minutes.
There may be dust inside a brand new tumble dryer.
Drying
1. Connect the appliance.
2. Open the door (see picture).
3. Load the items one at a time, shaking them out
loosely.
4. Close the door. Please check the laundry does not get
caught between the door and filter.
5. Select the drying programme or time. The lights
DRYING, COOLING and END come on. The light of
the START/PAUSE button flashes and the display
shows the duration of the programme.
6. If required, press the HALF POWER button and/or
the ALARM OFF button or the QUICK button.
7. Select the DELAY START if required. The selected
delay appears on the display for 2 seconds, then the
duration of the selected programme is displayed.
8. Press the START/PAUSE button: the corresponding
light stops flashing and drying starts. Only the
DRYING light stays lit. If you have selected the
DELAY START, the machine begins its countdown.
If the programme selector dial is turned to another
position, when the machine is running, the buzzer will
sound, the programme phase indicator lights will flash.
The drum turns alternately in both directions during
drying.
All drying programmes end with a 10 minute cooling
phase (COOLING light illuminates).
You may remove the laundry after this phase.
The lights END, FILTER and FULL TANK illuminate and
the buzzer sounds.
The display shows a static zero.
9. If the laundry is not removed at the end of the cycle,
the dryer performs an anti-creasing phase (duration:
30 minutes maximum).
If you do not remove the laundry, the dryer will stop
automatically at the end of the anti-creasing phase.
P1108 P1149
The END, FILTER and FULL TANK lights remain lit
and the buzzer sounds every 10 seconds for 2
minutes.
The light of the START/PAUSE button goes off and a
flashing zero appears on the display.
10. Turn the programme selector dial to “Off”; all the
lights go out. The appliance is switched off.
Remove the laundry.
If you open and then close the door before
turning the programme selector dial to
“Off ”, all the lights corresponding to the
phases making up the performed
programme come on and the display shows
the duration of the programme.
After each use
• Clean the filters (see page 17).
• Empty the water reservoir (see page 18).
Removing laundry or loading
laundry when necessary
1.Open loading door
Warning!
Laundryanddrumcanbecomehot.Riskof burns!
2.Load or remove laundry items.
3.Close the door securely. Lock must audibly lock.
4.Press the START/PAUSE button to continue the
drying cycle.
Modifying the programme
To change a programme which is running, first cancel it by
turning the programme selector dial to “Off”. Select the
new programme and press the START/PAUSE Button
.
125983041.qxp 2006-09-18 13:55 Page 13