John Lewis JLWM 1604 - Manual (Page 28)

6. Clean the filter in the valve with a stiff
brush or with the piece of cloth.
7. Screw the hose back to the machine
and make sure the connection is tight.
8. Turn on the water tap.
Emergency emptying out
If the water is not discharged, proceed as
follows to empty out the machine:
• pull out the plug from the power socket;
• close the water tap;
• if necessary, wait until the water has
cooled down;
• open the pump door;
• place a bowl on the floor and place the
end of the emergency emptying hose into
the bowl. Remove its cap. The water
should drain into the bowl. When the
bowl is full, put the cap back on the hose.
Empty the bowl. Repeat the procedure
until water stops flowing out;
• clean the pump if necessary as previously
described;
• replace the emergency emptying hose in
its seat after having plugged it;
• screw the pump cover again and close the
door.
Frost precaution
If the machine is exposed to temperatures
below 0°C, certain precautions should be
taken.
• Turn off the water tap.
• Unscrew the inlet hose.
• Place the end of the emergency emptying
hose and that of the inlet hose in a bowl
placed on the floor and let water drain
out.
• Screw the water inlet hose back on and
reposition the emergency emptying hose
after having put the cap on again.
• When you intend to start the machine up
again, make sure that the room
temperature is above 0°C.
28