V-chip – JVC AV-48WP30 User Manual
Page 38
V-Chip
38
Set Lock Code
Channel Guard and V-Chip settings are protected by a four-digit Lock Code. Your TV comes
pre-set with a Lock Code of “0000”. You may change the code to any four-digit number you
wish. To change the Lock Code, follow the steps below.
Access the onscreen menus by pressing M
ENU
on your remote control. You may then either
use the up and down arrows to scroll to the INITIAL SETUP menu, or press M
ENU
until the
INITIAL SETUP screen appears. Use the arrows to move to the Set Lock Code. Press the
¥or arrows to select.
The Padlock icon will appear. Press Zero on the remote’s 10-key pad to access the LOCK
CODE.
Use the ¥ or arrow to change the first digit.
When you have selected the first number, move
to the second digit by pressing the arrow. You
can change this digit using the ¥ arrows.
Repeat this process until all four digits are set.
When you have entered your LOCK CODE, press
to move to FINISH.
Press ¥or to exit.
FINISH
LOCK CODE
0000
Notes: In order for V-Chip settings to take effect, V-Chip settings must be turned ON in
the V-CHIP menu (page 35). You can automatically unblock all of your restrictions by turning
V-Chip settings OFF in the V-CHIP menu (page 35). You can always unblock a restriction by
re-entering the V-CHIP menu and removing the lock icon.