JVC KY-F1030U - Manual (Page 18)

E14
AC ADAPTER AA-P700
ON
OFF
POWER
AA-P700
AC
[IEEE1394]
[REMOTE]
[DC IN]
FOCUS LOCK
2. Before shooting
Connecting through digital output connector
The KY-F1030 can be remote-controlled from a personal computer, and the shot image can be
shown on the computer’s monitor.
<Connection Example> Shooting with the camera when the flash is fired by the timing of an
external trigger switch.
1. Connect the KY-F1030’s [IEEE1394] connector to the IEEE1394 host adapter on the PC.
2. Connect the flash and trigger switch to the [REMOTE] terminal.
3. Turn on the power of the KY-F1030.
* The power for KY-F1030 can be supplied from the IEEE1394 connector of personal com-
puter. However, be sure to use the AC adapter (AA-P700) when using the motorized lens
or when using both analog output and digital output in combination.
4. Turn ON the PC, and then start up the special application software KY-LINK.
* For how to operate the application software, see the Help file of the KY-LINK.
Connect to the power supply
(
੬
page E18)
AC adapter
Attach lens
(
੬
page E17)
Connecting the IEEE 1394
Cable (
੬
page E18)
Flash
Trigger switch
Special application software
KY-LINK
PC
IEEE1394
host
adapter
CAUTION
●
Do not turn the power switch on the AC adapter ON/OFF or unplug the IEEE1394 cable while the
application software is running.
●
Before using the computer with the KY-F1030, release any settings that automatically set the com-
puter in the Stand by or Hibernate mode.
MEMO
If two or more KY-F1030 cameras are connected to one computer, it is not possible to view the camera
images simultaneously.