Jabra SP5050 - Manual (Page 7)

5
Jabra JX10 Bluetooth headset
3. Your phone will find the Jabra SP5050.
Your phone then asks if you want to pair with it. Accept by
pressing ‘Yes’ or ‘OK’ on the phone and confirm with the pass-
key or PIN = 0000 (4 zeros). Your phone will confirm when pair
ing is complete.
4. In case of unsuccessful pairing, repeat steps 1 to 3.
You can manually put your Jabra SP5050 into pairing mode, if
you want to pair with a new phone:
1. Make sure the Speakerphone is off.
2. Press and hold the answer/end button for approx 7 sec.
until the connection status indicator light starts blink
continuously.
3. Set your Bluetooth phone to discover your Speakerphone
like described above
5 HOW TO…
Answer a call
• Tap the answer/end button
End a call
• Tap the answer/end button
Make a call
• When you make a call from your mobile phone, the call will
(subject to phone settings) automatically transfer to your
Speakerphone. If your phone does not allow this feature, press
on the Jabra SP5050’s answer/end button to transfer the call to
the Speakerphone.
Reject a call*
• Press the answer/end button when the phone rings to reject an
incoming call. Depending on your phone settings, the person
who called you will either be forwarded to your voice mail or
hear a busy signal.
Activate voice dialling*
• Press the answer/end button. For best results, record the voice-
dialling tag through your Speakerphone. Please consult your
phone’s user manual for more information about using this
feature.
* Phone dependent