Jensen VR182 - Manual (Page 16)

VR182
16
TROUBLESHOOTING SPECIFICATIONS
CD
Signal to Noise Ratio. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . > 60dB
Channel Separation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . : More than 50 dB
Frequency Response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .: 40Hz - 18 kHz
FM Radio
Frequency Coverage (USA) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 87.5 to 107.9 MHz
Frequency Coverage (Europe) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 87.5 to 108 MHz
Sensitivity (S/N=30dB) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4µV
Image Rejection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . >45 dB
Stereo Separation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . >25dB
AM/MW
Frequency Range (USA) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 530-1710KHz
Frequency Range (Europe). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 522-1620KHz
Sensitivity (S/N=20dB) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36 dB
General
Operating Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .DC 12 Volts
Grounding System. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Negative Ground
Speaker Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4-8 ohms per channel
Tone Controls:
Bass (at 100 Hz). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . : ±10 dB
Treble (at 10 kHz). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . : ±10 dB
Power Output . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40W x 4
Current Drain. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15 Ampere (max.)
Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 80 (W) x 183 (D) x 100 (H)
Symptom Cause Solution
No power The vehicle’s ignition is not
on If the power supply is properly
connected to the vehicle acces-
sory terminal, switch the ignition
key to “ACC”.
The fuse is blown Replace the fuse.
Disc cannot be loaded or
ejected Presence of CD disc inside
the player Remove the disc in the player and
insert the new one.
Inserting the disc in reverse
direction Insert the compact disc with the
label facing upward.
Compact disc is extremely
dirty or disc is defective Clean the disc or try to play a new
one.
Temperature inside the
vehicle is too high Wait until the ambient tempera-
ture returns to normal.
Condensation Leave the player off for an hour or
so, then try again.
No sound Volume is too low Adjust volume to audible level.
Wiring is not properly con-
nected. Check wiring connections.
The operation keys do
not work Control panel not properly
installed Reinstall control panel.
The built-in microcomputer
is not operating properly
due to noise Press the RESET button.
Sound skips The installation angle is
more than 30 degrees. Adjust the installation angle to
less than 30 degrees.
The disc is dirty or defec-
tive. Clean the disc and try to play
again or use new disc.
Cannot tune to radio sta-
tion, auto-seek does not
work The antenna cable is not
connected. Insert the antenna cable firmly.
The signals are too weak. Select a station manually.
ASA Electronics Corporation
www.asaelectronics.com
© 2007 ASA Electronics Corporation
v.022207