JVC KS-FX850R - Manual (Page 32)

32
ENGLISH
1. Remove the battery holder.
1) Push out in the direction indicated by the arrow
using a ball point pen or a similar tool.
2) Remove the battery holder.
2. Place the battery.
Slide the battery into the holder with the + side facing
upwards so that the battery is fixed in the holder.
3. Return the battery holder.
Insert again the battery holder pushing it until you
hear a clicking sound.
(back side)
1)
2)
(back side)
Lithium coin battery
(product number:
CR2025)
REMOTE OPERATIONS
This section is ONLY FOR KS-FX850R and KS-FX835R.
KS-FX820R can also be remotely controlled as instructed here (with an optionally purchased
remote controller). We recommend that you use remote controller RM-RK31 with your unit.
The followings are the instructions for using RM-RK31.
Installing the battery
When the controllable range or effectiveness of the remote controller decreases, replace
the battery.
Before using the remote controller:
• Aim the remote controller directly at the remote sensor
on the main unit. Make sure there is no obstacle in
between.
• Do not expose the remote sensor to strong light (direct
sunlight or artificial lighting).
Remote sensor
WARNING:
• Store the batteries in a place which children cannot reach.
If a child accidentally swallows the battery, immediately consult a doctor.
• Do not recharge, short, disassemble or heat the batteries or dispose of in a fire.
Doing any of these things may cause the batteries to give off heat, crack or start a fire.
• Do not leave the batteries with other metallic materials.
Doing this may cause the batteries to give off heat, crack or start a fire.
• When throwing away or saving the batteries, wrap in tape and insulate; otherwise, , it may cause
the batteries to give off heat, crack or start a fire.
• Do not poke the batteries with tweezers or similar tools.
Doing this may cause the batteries to give off heat, crack or start a fire.
EN32-33.KS-FX850R[E]/f 00.1.20, 6:43 PM 32