JVC SX-LC33 - Manual (Page 3)

3
English
Connection
Type: 2-way 3-speaker bass-reflex type
Magnetically-shielded type
Speakers
Woofer: 13.5 cm cone x 2
Tweeter: 1.9 cm dome x 1
Power handling capacity: 120 W
Specifications
7
Connecting the speaker cord to the speaker
Connect the speaker cord to the speaker as follows.
1 Twist and remove the insulation at the end of each
speaker cord before connecting.
2 Rotate the speaker terminal knob counterclockwise and
fit the speaker cord into the groove. Then rotate the knob
clockwise to secure the cord.
7
Connecting the speaker system to the amplifier
Before connection—
• Turn off the power to the amplifier before connecting the
speaker system; otherwise, the speakers may be damaged.
• The impedance of the speaker is 6 Ω. Before connecting it to
your amplifier, check the speaker impedance range of your
amplifier. If the impedance of this speaker is out of the speaker
impedance range indicated on the amplifier, you cannot
connect this system to the amplifier.
• The maximum power handling capacity of the SX-LC33 is
120 W. Excessive input will result in abnormal noise and
possible damage.
• Be sure to turn down the volume level to prevent unwanted
noise before performing following operations:
– Turning on or off other components,
– Operating the amplifier,
– Tuning FM stations,
– Fast-forwarding a tape,
– Continuously reproducing high frequency oscillation or high
pitch electronic sounds.
• When using a microphone, do not aim it at the speakers or
use it near the speakers; otherwise, the howling which occurs
may damage the speakers.
• Before replacing the cartridge, always turn off the power to the
turntable; otherwise, the clicking noise may damage the
speakers.
Impedance: 6 Ω
Crossover frequency: 4 000 Hz
Frequency range: 52 Hz to 80 000 Hz
Sound pressure level: 89 dB/W•m
Dimensions (W x H x D): 150 mm x 415 mm x 292.5 mm
Mass: 8.0 kg
Design and specifications subject to change without notice.
About speaker cords—to improve the sound quality
About the OFC cord
The core wires of the supplied speaker cords are made of OFC (Oxygen Free Copper). This OFC cord enables high quality
sound reproduction.
When connecting the speaker cords
Make sure to match the polarity (
ª and ·); otherwise, the surround effect will become less effective.
After connecting, check that the exposed cores are fully inserted into the terminal.
When using other speaker cords
Observe the following;
• Buy thick speaker cords rather than thin cords, and make them as short as possible for connection.
• Do not use long speaker cords; otherwise, the sound quality may deteriorate.
• Use speaker cords of the same length for both left and right speakers.
• Using a special speaker cord such as a litz wire, a coaxial cable, or a cord which has the specified connecting directionality
may influence the sound quality.
Tighten
Loosen
Silver
ª terminal
(Red)
· terminal
(Black)
Copper
To the speaker ª
terminal of amplifier
To the speaker ·
terminal of amplifier
EN_SX-LC33[U_UP]f.p65 04.7.26, 3:50 PM 3