Jeep 50-0284x-015 Series - Manual (Page 3)

3
I. PREPARATION OF VEHICLE INTERIOR
1. Using the rear edge of O.E. console as a reference
location, carefully measure & trim headliner as
shown. Use a razor knife to score the first layer
and scissors to cut remaining layers. Caution:
Before cutting headliner material, check for
wiring or other componentry above headliner.
Cut only where indicated. Wear safety goggles
when cutting headliner material. Make sure
that the 9" & 7" cuts are centered left to right in
vehicle. See Figure 1.
DO NOT OVERCUT HEADLINER.
2. Scribe a center line on the sheet metal roof of
the vehicle from front to rear of opening in
headliner. This will be used for bracket
alignment. See Figure 1.
3. Remove and retain (1) one screw which secures
front O.E. console. Pull downward to release
console. See Figure2.
4. Using a 3/8" drill bit, make an access hole in rear
of plastic bracket. Caution: Drill toward rear
of vehicle. See Figure 3.
5. Construct a jumper harness that will connect the
vehicle’s dome light wires to the lights in video
system. Connect the white wire to the O.E. pink
wire. Connect the black wire to the O.E.
yellow/green wire. See Figure 3.
6. Using a test light, test function of lights.
7. Install O.E. console.
FIGURE 2
FIGURE 1
FIGURE 3