Jabra BT2045 - Manual (Page 6)

5
en
g
li
sh
Jabra bT2045
Please note that the led indicator light turns off after 1 minute to
save battery . headset is still active, and light will flash again after
tap on the answer/end button or any call activity . To check if the
headset is on, tap the answer/end button once – the led indicator
light will flash, if the headset is on .
PaIrInG It WIth your Phone
headsets are connected to phones using a procedure called
‘pairing’ . by following a few simple steps, a phone can be paired
with a headset in a matter of minutes .
1. Put the headset in pairing mode
- When you turn on your Jabra bT2045 for the first time, the
headset will automatically start up in pairing mode – i .e . it is
discoverable for your phone . When the headset is in pairing
mode the led is constantly lit .
2. Set your phone to ‘discover’ the Jabra BT2045
- follow your phone’s instruction guide . first make sure that
Bluetooth® is activated on your mobile phone . Then set your
phone to discover the headset . This usually involves going
to a ‘setup’, ‘connect’ or ‘Bluetooth® ’ menu on your phone and
selecting the option to ‘discover’ or ‘add’ a device .*
3. Your phone will find the Jabra BT2045
- your phone will find the headset under name “bT2045” . your
phone then asks if you want to pair with the headset . accept
by pressing ‘yes’ or ‘ok’ on the phone and confirm with the
passkey or PIn = 0000 (4 zeros) if asked . your phone will
confirm when pairing is complete .
CONNECTIVITY
SELECT
MobilSurf
BLUETOOTH
Infrared port
Wap options
Synchronization
Networks
DEVICES FOUND
OK
Passkey:
****
HANDSFREE
SELECT SELECT
Bluetooth Headset
Bluetooth
Headset is now
ready for use
Bluetooth Headset
* Phone dependent