JVC BC-D2300U - Manual (Page 10)

18
OTHERS
Rear panel connectors
Names Functions Types Remarks
SDI IN SD digital serial signal input BNC
SDI OUT Active through output BNC
REF External sync input BNC
REF Loop-through BNC
HD SERIAL OUT 1 HD digital serial signal output BNC
HD SERIAL OUT 2 Same as above BNC
HD SERIAL OUT 3 Same as above BNC
CVBS Analog composite input BNC The optional BC-D231 is required.
Y Analog component Y input BNC
Pr Analog component Pr input BNC
Pb Analog component Pb input BNC
ALARM [ALARM] connector/RS-232C D-SUB 9-pin male, inch screw
REMOTE-IN Remote control input D-SUB 9-pin female, mm screw
REMOTE-OUT Remote control bridge D-SUB 9-pin female, mm screw
1 5
9 6
1. Before connecting the power cable, install the supplied hook as
shown on the left.
2. After connecting the power cable, lower the hook to secure the
power cable in place.
Installing the power cable hook
Pin Signal
I/O Contents Remarks
number name
1 NC — Unconnected
2 TxA O Transmission A RS-485
3 RxB I Reception B RS-485
4 SG — Signal ground
5 NC — Unconnected
6 SG — Signal ground
7 TxB O Transmission B RS-485
8 RxA I Reception A RS-485
9 NC — Unconnected
Ⅵ REMOTE-IN, REMOTE-OUT terminal pin assignment
Note:
● For the REMOTE connection, use a straight cable
which contains twisted paired lines for the signals of
TxA and TxB, RxA and RxB.
Hook
19
5 Input signal
Video and audio : SD digital serial signal (SMPTE259M) ................... 1 line
0.8 Vp-p, 75 ohms unbalanced, active-through
Bit rate: 270 Mbps
Embedded audio signal: 4 ch, sampling frequency of 48 kHz
Sync signals : Sync signal, 75 ohms unbalanced, loop through .... 1 line
B.B: 0.45 Vp-p (NTSC)
HD-SYNC: Positive and negative bipolarity tri-sync signal of 600 mVp-p ± 300 mVp-p
5 Output signal
Video and audio : HD digital serial signal
(SMPTE292M) ..................................................... 3 lines
0.8 Vp-p, 75 ohms unbalanced
Bit rate: 1.485/1.001 (1.483516) Gbps, 59.94 Hz
Effective scanning lines: 1080 lines (1080I), 720 line (720P)
Embedded audio signal: 4 ch, sampling frequency of 48 kHz
5 Quantization
Video resolution : 10 bits
Audio resolution : 20 bits
5 Signal delay amount
Video system : 1 frame or 1 frame - 90H, the shortest delay setting not available
Audio system : The same delay as the video delay time, can be adjusted by ±30 msec.
5 Conversion mode : Three types (4:3 material, letter box material, squeezed material)
5 Power supply : AC 120 V, 50 Hz/60 Hz
5 Power consumption : 35 W
5 External dimensions
(WHD)
: 430 mm x 489 mm x 50 mm
(16-15/16" x 19-5/16" x 2") (excluding fan motor and connectors)
5 Weight : 6.2 kg (13.7 lbs.)
5 Using environment
Installation place : In a room (install on a table or a rack)
Allowable operating
temperature
: 10˚C to 40˚C (50˚F to 104˚F)
Allowable operating
humidity
: 30%RH to 80%RH (with no condensation)
Allowable storage
temperature
: –20˚C to 60˚C (–4˚F to 140˚F)
5 Provided accessories and
options
: Warranty card x 1
Instruction manual x 1
Service center list x 1
Power cable (2.5 m) x 1
Rack mount bracket x 2
Screw (M4) x 4
Screw (M5) x 4
Hook (for power cable) x 1
Specifications