Jensen PS475 - Manual (Page 7)

PS475
7
RCA Output
Cableado de la Salida
Câblage de Rendement
80 180 300
Hz Hz
2 4 5
1.4
80
180
300 80
180
300
Hz Hz
4 5 1.4 80 180 300 80 180 300
Hz Hz
80 180 300
Hz Hz
2
Splice (as necessary)
Empalme (como necesario)
Épissez (selon les besoins)
Gray - Right (+)
Gris - La Derecha (+)
Gris - La Droite (+)
Gray/Black - Right (-)
Gris/Negro - La Derecha (-)
Gris/Noir - La Droite (-)
Violet - Right (+)
Violeta - La Darecha (+)
Violet - La Droite (+)
Violet/Black - Right (-)
Violeta/Negro - La Darecha (-)
Violet/Noir - La Droite (-)
A B C D E
F G H I
Black - Ground
Negro - Tierra
Noir - La Terra C) D) E)
I) H)
Green - Left (+)
Verde -
Green/Black - Left (-)
La Izquierda (+)
Vert - La Gauche (+)
Verde/Negro - La Izquierda (-)
Vert/Noir - La Gauche (-)
B)
G)
White - Left (+)
Blanco - La Izquierda (+)
Blanc - La Gauche (+)
White/Black - Left (-)
Blanco/Negro - La Izquierda (-)
Blanc/Noir - La Gauche (-)
A)
F)
3 Channel 4 Channel 2 Channel
Pass-Thru RCA Outputs
The output signal allows you to conveniently connect other amplifiers to each other.
Input Wiring
Low Level Input (RCA Input)
Low level (RCA) input is preferred for best performance. Most trunk/hatchback installations will
require a 15-20 foot RCA cable, while pickup trucks and under-seat mounting will require a 6-12
foot RCA cable. Connect an RCA cable from your receiver to the RCA input on your amplifier.
High Level Input
High level input should be used when an RCA output is not available from the receiver. Connect
the speaker outputs from the receiver to the high level input connector.
Note: Only connect the low (RCA) or high level input, not both at the same time.
2 Channel / 3 Channel / 4 Channel
The PS475 can be configured for three different input modes: 2 channel, 3 channel or 4 channel.
Input Wiring
Cableado de Entrada