Troubleshooting, Specifications – JVC CA-MXKA3 User Manual

Page 28

Advertising
background image

26

Troubleshooting

• If you are having a problem with your System, check this list for a possible solution before calling for service.
• If you cannot solve the problem from the hints given here, or the System has been physically damaged, call a qualified person, such as

your dealer, for service.

Symptom

Possible Cause

Action

No sound is heard.

• Connections are incorrect, or loose.

• Headphones are connected.

• Check all connections and make cor-

rections. (See pages 4 to 6.)

• Disconnect the headphones.

Poor radio reception

• The antenna is disconnected.
• The AM Loop Antenna is too close

to the System.

• The FM Wire Antenna is not prop-

erly extended and positioned.

• Reconnect the antenna securely.
• Change the position and direction of

the AM Loop Antenna.

• Extend FM Wire Antenna to the best

reception position.

The disc tray does not open.

• The AC power cord is not plugged in.
• Tray is locked.

• Plug the AC power cord.
• Unlock the tray. (See page 15.)

The CD skips.

The CD is dirty or scratched.

Clean or replace the CD. (See page 25.)

The CD does not play.

The CD is upside down.

Put the CD in with the label side up.

The cassette holder cannot be opened.

During tape playing, the power cord
was unplugged.

Plug in the power cord, and turn on the
System.

Unable to record.

Cassette record protect tabs are re-
moved.

Cover holes on back edge of cassette
with tape.

Unable to operate the Remote Control.

• The path between the Remote Con-

trol and the sensor on the Unit is
blocked.

• The batteries have lost their charge.

• Remove the obstruction.

• Replace the batteries.

Operations are disabled.

The built-in microprocessor has mal-
functioned due to external electrical in-
terference.

Unplug the System then plug it back in.

Specifications

Amplifier

Output Power 45 W per channel, min. RMS, driven into

6

Ω at 1 kHz, with no more than 10 % to-

tal harmonic distortion (IEC268-3)

Input Sensitivity/Impedance (1 kHz)

AUX IN 300 mV/50 k

Speaker terminals 6 - 16

Phones 32

Ω - 1 kΩ,

15 mW/ch output into 32

Cassette Deck Section

Frequency Response

Type I (NORMAL) 63 Hz - 12 500 Hz

Wow And Flutter 0.15% (WRMS)

CD Player

CD Capacity 3 CDs

Dynamic Range 85 dB

Signal-To-Noise Ratio 85 dB

Wow And Flutter Unmeasurable

Tuner

FM Tuner

Tuning Range 87.50 - 108.00 MHz (at AM 9 kHz channel space)

87.5 - 108.0 MHz (at AM 10 kHz channel space)

AM Tuner

Tuning Range 531 - 1 710 kHz (at 9 kHz channel space)

530 - 1 710 kHz (at 10 kHz channel space)

Unit

Dimensions 267 mm

305 mm

433 mm (W/H/D)

Mass Approx. 7.5 kg

Speaker Specifications (each unit)

SP-MXKA3

Type 3-way bass-reflex type

Speaker Unit Woofer: 13.5 cm cone

1

Mid:

5 cm cone

1

Tweeter: 2 cm dome

1

Power Handling Capacity 45 W

Impedance 6

Frequency Range 45 Hz - 22 000 Hz

Sound pressure level 89 dB/wm

Dimensions 228 mm

316 mm

258 mm (W/H/D)

Mass Approx. 3.1 kg

Accessories

AM Loop Antenna (1)
Remote Control (1)
Batteries R6P (SUM-3)/AA (15F) (2)
FM Wire Antenna (1)
AC Plug Adaptor (1)

Power Specifications

Power Requirements AC 110/127/220/230 - 240 V

, adjust-

able with the voltage selector, 50/60 Hz

Power Consumption 100 W (power on mode)

16 W (in Standby mode)

Design and specifications are subject to change without notice.

Body.fm Page 26 Wednesday, March 12, 2003 4:47 PM

Advertising
This manual is related to the following products: