Jet Tools PDS-12CS - Manual (Page 8)

8
Contents of the Shipping Carton
PDS-12CS 12” Disc Sander
1. Sander
1. Sanding
Disc
1. Table
1. Miter
Gauge
1. Miter Gauge Fence
1. Owner's
Manual
1. Warranty Card
Hardware Kit
4. Hex Head Bolt M10x35
4. Flat Washer M10
4. Lock Washers M10
2. Hex Nut M6
4. Pan Head Flange Screw M6x12
1. Center
Point
1. Right Angle Hex Wrench 3mm
1. Filler
Bar
1. Socket Head Cap Screw M5x8
Closed Stand
1. Stand
1. Inlet
2. Hangers
1. Ring
Clamp
1. Collector Bag
Tools Required for Assembly &
Adjustments
1. 13mm Wrench or socket
1. Combination
Square

WARNING
Read and understand the entire contents of
this manual before attempting assembly or
operation of the disc sander!
Failure to comply may cause serious injury!
Unpacking
1. Remove all contents from the shipping
carton(s).
2. Report any damage to your distributor.
3. Do not discard any shipping material until
the sander has been assembled and is
running properly.