Jacuzzi J-280 - Manual (Page 19)

page 15
10. Leave spa cover open during this step to allow
excessive chemical vapors to exit spa, protect-
ing pillows and plastic knobs from chemical at-
tack. If spa is indoors, open doors and windows
for proper ventilation. Turn on all jet pumps for
one hour, then place the massage selector knob
in the center “combo” position and open all air
controls. Note: You will need to press the jets
pump button(s) every 20 minutes since these
functions have an automatic 20 minute time-out
function that turns them off.
CAUTION: never leave your spa unattended for any reason
while the cover is open and accessible to small children and
animals!
11. Turn off power to the spa at the circuit breaker, then drain spa as
outlined in section 11.2 “Draining And Refilling” (page 27).
12. Fill spa until water covers all jets but does not touch the bottom of
the lowest headrest. DO NOT OVERFILL.
CAUTION: Never fill with water from a water softener. If your
water is extremely “hard”, it is preferable to fill half-way with
hard water and the rest of the way with softened water. Or,
you may fill entirely with hard water if you use a special water
additive available from your authorized Jacuzzi dealer.
13. Consult your authorized Jacuzzi dealer for chemical recommenda-
tions, then add chemicals to spa water to achieve a constant sani-
tizer reading within the levels recommended by the Association of
Pool And Spa Professionals/USA printed on the inside cover of this
manual.
14. Turn on all jet pumps when adding chemicals to ensure proper mix-
ing and leave your spa cover open until the sanitizer level falls below
4.0 ppm to protect pillows and plastic knobs from chemical
attack.
CAUTION: Never leave your spa unattended for any reason
while the cover is open and accessible to small children and
animals.
Set all air controls
to their full open
counterclockwise position
Massage Selector
Set all air controls
to their full open
counterclockwise position
Massage Selector