John Lewis JLDV 02 - Manual (Page 17)

17
Adjusting the level of conductivity
Water contains, a variable quantity of limestone and
mineral salts of which quantities vary according to
geographical locations thus varying its conductivity values.
Relevant variations of the conductivity of the water
compared to those prefixed by the factory could slightly
influence the residual humidity of the laundry at the end
of the cycle.
Your dryer allows you to regulate the sensitivity of the
drying sensor based on conductivity values of the water
by using the following procedure
.
To establish the hardness of your water to correspond
with the table opposite please contact your local water
authority.
Procedure:
Turn the programme selector dial to switch on the
appliance
In selection mode press simultaneously the buttons 3 and
6 until «C0» appears on the digits.
Adjusting the level of conductivity:
Press the button 5 sequentially: the level of conductivity is
indicated by the lighting of the horizontal hyphens
.
1 2 3 4 5 6
Delay start Door Quick Half power Alarm off
Dry time
Drying
Cooling
End
Filter
Start / Pause
Synthetics
Extra dry
Store dry
Cupboard dry
Damp dry
Iron dry
Extra damp
Extra dry
Cupboard dry
Cottons
Iron dry
Heavy cotton
Off
Delicates 2kg
30 minutes
Refresh
Cooling 10 minutes
Extra delicate
Memorising the new setting:
Simultaneously press down the buttons 3 and 6 until the
previous drying cycle time appears again on the display
and the buzzer sound
s.
Display
Conductivity
degree
Approximative
value (µS/cm)
C C 0 0 Low < 300
C C 0 0 Medium 300 - 600
C C 0 0 High > 600
125983050.qxp 2006-01-24 15:46 Page 17