JVC CA-MXG51R - Manual (Page 12)

– 9 –
Common Operations
Turning On or Off the Power
To turn on the unit, press
STANDBY/ON so that the STANDBY
lamp goes off.
To turn off the unit (on standby), press
STANDBY/ON again so that the
STANDBY lamp lights up.
A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to “– – : – –” soon, while the tuner preset stations
(see page 11) will be erased in a few days.
Saving the Power Consumption While on
Standby — ECO-mode
You can save the power consumption only while the unit is
turned off (on standby).
To activate the ECO-mode, press ECO
while the unit is turned off (on standby).
The display illumination (including the
display demonstration) disappears.
To deactivate the ECO-mode, press ECO again.
The display illumination appears.
About ECO-mode
While ECO-mode is activated, the display demonstration is canceled
temporarily.
Setting the Clock
Before operating the unit any further, first set the clock built in
this unit. You can set the clock whether the unit is on or off.
On the unit ONLY:
1
Press CLOCK/TIMER.
DAILY
Canceled
ON TIME
ON TIME CLOCK
REC
3
Press
4 or ¢ to adjust the
minute, then press SET.
To check the clock time
Press DISPLAY while playing any source.
• Each time you press the button, the source
indication and the clock time alternate on the
display.
To adjust the clock again
If you have adjusted the clock before, you need to press
CLOCK/TIMER repeatedly until “CLOCK” is selected.
• Each time you press the button, the clock/timer setting
modes change as follows:
If there is a power failure
The clock loses the setting and is reset to “– – : – –.” You need to set
the clock again.
Selecting the Sources
To listen to the FM, MW or LW broadcasts, press FM/AM.
(See page 11.)
To play back CDs, press CD
6. (See pages 14 – 16.)
To play back tapes, press TAPE
3. (See page 17.)
To select the external equipment as the source, press AUX.
When you press the play button for a particular source (AUX,
FM/AM, CD
6, and TAPE 3), the unit turns on (and the
unit starts playing the source if it is ready — COMPU PLAY
CONTROL).
STANDBY/ON
STANDBY
ECO
STANDBY/ON
STANDBY
ECO
PRESET
SET
DISPLAY
CLOCK
/ TIMER
STANDBY/ON
STANDBY
ECO
2
Press
4 or ¢ to adjust the
hour, then press SET.
• If you want to correct the hour after
pressing SET, press CANCEL. The
hour digits start flashing again.
The hour digits start
flashing on the display.
PRESET
SET
EN01-13.CA-MXG51R[B]_f 01.2.15, 8:51 PM 9