JobSite Systems LST-RLS - Manual (Page 5)

3
6. Locate the cutout template.
7. Use a pencil and the cutout template to
trace the speaker outline in the desired
locations on the wall.
8. Use a drywall saw to cut along the
penciled line.
9. Slip the mounting bracket through the
opening and pull it toward you so that its
front edge slides into the hole and stops
in place.
10. Attach the frame to the bracket by
screwing the frame to the bracket using
the supplied screws. NOTE: Do not over
tighten the screws, this will distort the
frame and the grille will not fit.
11. The screws should pull the frame and
bracket together (sandwiching the
drywall) so that the frame is flush with
the wall surface.
12. Strip 1/4” of insulation from the end of
each wire.
13. Tightly twist the end of each wire until
no frayed ends remain.
14. Attach the speaker wires to the speaker
terminal connectors. Connect the
negative output from the amplifier to the
black terminal. Connect the positive
output from the amplifier to the red
terminal.
15. Set the speaker configuration switches
on the rear of the speaker (see Setting
the Speaker Configuration Settings).
16. Install the speaker in the frame. Screw
the enclosed self-tapping screws into
the dimples of the speaker baffle as
shown in Figure 2.
17. Repeat steps 1-16 for each speaker
being installed.
18. After making tonal adjustments on all
speakers (see Setting the Speaker
Configuration Settings), install the grill
into the speaker.
Figure 2
DS00388ACN-LST_RLS-CTR.qxp 11/18/04 9:15 PM Page 3