JVC Kaboom ! Series RV-B550BU - Manual (Page 25)

25
SLEEP
SLEEP
1 3
SLEEP
CLOCK TIMER
TIMER
ON/OFF
PROGRAM
DOWN UP SET
2
BEAT CUT
AUX
PRESET
TUNING
ONE TOUCH
REC
VOLUME
C D TAPE TUNER
MULTI CONTROL
REW ACS STOP FF
BAND
STANDBY
ON/STANDBY
AHB PRO
AHB PRO
SPEAKER
ILLUMINATION
/ACS SOUND
Timer playback
÷ Timer playback of tapes, broadcasts and CDs is possible.
Operations
÷ Any source can be selected for sleep timer operation and timer playback.
For example;
• CD play for sleep timer operation and broadcast reception for timer
playback.
• Tuner play for sleep timer operation and CD play for timer playback.
However, when broadcast reception is selected for both sleep timer
operation and timer playback, the station you heard at night will be tuned
to the following morning.
SLEEP is shown in the display.
Source sound
CD play
Tape playback
Broadcast
1 Set the button to ON.
2 Set the timer. (Refer to “Setting the timer” on page 23.)
3 Set the button to STANDBY.
÷ Timer playback will start at the timer start time and the power will be
switched off at the timer stop time.
The unit remains in the same timer mode even after the power is
switched off. The same timer function will repeat at the same time on
the following day.
÷ When the timer mode is activated, the “ ” indicator blinks.
÷ When the power is switched on, the sound is faded up from volume
level 0 (zero) to the preset volume.
÷ To cancel timer operation
Press the TIMER ON/OFF button so that the timer mode indicator (
)
goes out.
Notes:
÷ When the volume setting is set to “VOL -” (volume level is not specified),
the timer playback volume is at the level used before setting the timer. (In
this case, the fade-in mode does not function.)
÷ To stop during timer playback, press the button to switch the unit
off.
Timer mode
CD
TAPE
TUNER
Operations
Load a disc.
Load a cassette tape.
Tune to the required station.
Source mode display (Releasing the sleep mode)
÷ Sleep time settings of 30, 60, 90 or 120 minutes can
be set. When you release the SLEEP button, the
source is displayed after 5 sec.
÷ The sleep timer operation will start and the power will be switched off
after the specified time.
÷ Checking the sleep time
When the SLEEP button is pressed, the remaining sleep time is
displayed. If it is pressed again, a new sleep time can be set.
÷ To cancel the sleep timer operation
Press the
button to switch the power off or press the SLEEP button
until the sleep time indicator disappears.
Source mode display (Releasing the sleep mode)
Sleep timer operations (using the remote control unit)
A. Use this when you want to fall asleep while listening to a
tape, broadcast or CD.
1 Set to the required source and tune in a broadcast or play back a CD
or tape.
2 Press the SLEEP button to set the sleep time.
B. To fall asleep while listening to a tape, broadcast or CD
and to perform timer playback the following morning
1 Set the timer. (Refer to “Setting the timer” on page 23.)
2 Set to the required source (tape, broadcast or CD).
3 Press the SLEEP button to set the sleep time.