Jensen CD6112 User Manual
Page 7
3
CD6112
7.
Test the radio using the Operating Instructions that follow.
Kit Installation
If your vehicle requires the use of an installation kit to mount this radio,
follow the instructions included with the installation kit to attach the radio to
the mounting plate supplied with the kit.
1.
Wire and test the radio as outlined in the Universal Installation instruc-
tions.
2.
Install the radio/mounting plate assembly to the sub-dashboard
according to the instructions in the installation kit.
3.
Attach the support strap to the radio and dashboard as described in the
Universal Installation instructions.
4.
Replace the dashboard trim panel.
ISO Installation
This unit has threaded holes in the chassis
side panels which may be used with the
original factory mounting brackets of some
vehicles to mount the radio to the
dashboard. Please consult with your local
car stereo shop for assistance on this type
of installation.
1.
Remove the existing factory radio
from the dashboard or center console
mounting. Save all hardware and
brackets as they will be used to mount the new radio.
2.
Carefully unsnap the plastic frame from the front of the new radio
chassis. Remove and discard the frame.
3.
Remove the factory mounting brackets and hardware from the existing
radio and attach them to the new radio. Do not exceed M5 x 9 MM
maximum screw size. Longer screws may damage components inside
the chassis.
4.
Wire the new radio to the vehicle as outlined in the Universal Installation
instructions.
5.
Mount the new radio assembly to the dashboard or center console
using the reverse procedure of step 1.
Fuses
When replacing a fuse, make sure the new fuse is the correct type and
amperage. Using an incorrect fuse could damage the radio.
Reconnect Battery
When wiring is complete, reconnect the battery negative terminal.
Removing the Radio
To remove the radio after installation, remove the trim ring by lifting in the
center and pulling it off from either side. Insert the removal keys straight
back until they lock, then pull the radio out. If removal keys are inserted at
an angle, they will not lock properly and will not release the unit.
Technical Assistance
If you require assistance, contact Technical Support at 1-800-323-4815
from 9:00am to 6:00pm EST Monday through Friday.
MOUNTING
RUBBER
MOUNTING BOLT
RADIO
TRIM RING
BEND TABS
SLEEVE
CUSHION