Jensen JIMS-125I - Manual (Page 8)

1
2. Your iPod/iPhone will communicate with the unit and automatically sync the time
with your iPod/iPhone time and show it on the LCD Display after about 5 seconds.
Tips:
 The iPhone receives constant updates from the phone service provider, so the
iPhone time will always be accurate.
 The time on your iPod was undated with your computer the last time the iPod was
attached and synced with it. We recommend you to calibrate your computer’s
system clock and sync your iPod with iTunes right before docking into the unit to
make sure the current time is accurate.
 The Automatic Time Sync does not support earlier iPod models, like iPod mini and
iPod photo (4G/color display)
 When first docked, the iPod/iPhone will run an authentication process internally, so
it may not respond to any keys when pressed.
 A 59 second difference between the clock on the unit and the synced iPod/iPhone
is possible.
If you need to change the time after using the automatic time sync, you will have to do
it manually.
TO SET THE TIME MANUALLY
1. In Standby mode, press and hold the MEM.SET/CLK.ADJ. button of the unit,
“12 Hr” will blink.
2. Press the  or  button to set the unit to the 24-hour mode or 12-hour mode.
3. Press the MEM.SET/CLK.ADJ. button then the hour digits will blink.
4. Press the  or  button to adjust the hour. Press and hold the button for fast
advance / reverse setting.
Note: Make sure the hour is set so that the PM indicator is displayed correctly.
5. Press the MEM.SET/CLK.ADJ. button to confirm the hour setting, the minute digits
will flash to prompt for input.
6. Press the  or  button to adjust the minute. Press and hold the button for fast
advance / reverse setting.
7. Press the MEM.SET/CLK.ADJ. button again to complete the setting.
ALARM SETTING
1. In Standby mode, press the ALARM 1 or ALARM 2 button once to check the alarm
time and wake up option (iPod, Beep Alarm, Radio).
2. Hold the ALARM 1 or ALARM 2 button for 3 seconds when the alarm time is
showing. The hour digits will blink.
3. Press the  or  button to adjust the hour. Press and hold the button for fast
advance / reverse setting.
4. Press the ALARM 1 or ALARM 2 button to confirm the hour setting, the minute
digits will flash to prompt for input.