Jenn-Air PRO-STYLE 8112P342-60 - Manual (Page 10)

9
Surface burner fails to light. • Check to be sure unit is properly connected to power supply.
• Check or re-set circuit breaker. Check or replace fuse.
• Check power supply.
• Check to be sure burner is correctly rated for your kind of gas.
• Check to be sure burner ports or ignition ports are not clogged.
• Check to be sure ignitor is dry and clicking. Burner will not light if ignitor is damaged,
soiled or wet. If ignitor doesn’t click, turn control knob OFF.
• Check to be sure burner cap is correctly seated on the burner base.
Surface burner flame lifts • Check to be sure a pan is sitting on the grate above.
off ports. • Contact an authorized Jenn-Air servicer.
The flame is uneven. • Burner ports may be clogged.
• Flame may need to be adjusted. Contact an authorized Jenn-Air servicer.
Surface burner flame is • Some yellow tips on the flame are acceptable when using LP gas.
yellow in color. • Contact an authorized Jenn-Air servicer.
PROBLEM SOLUTION
T
ROUBLESHOOTING
8/9/06, 9:27 AM 10