JVC CA-VSDT9R - Manual (Page 19)

16
Using the Tuner
Presetting Stations
(Using the Remote Control)
You can preset up to 30 FM stations and up to 15 AM (MW/
LW) stations.
• Preset numbers may have been set to factory test fre-
quencies prior to shipment. This is not a malfunction. You
can preset the stations you want into memory by following
one of the presetting methods below.
Manual Presetting
1 Select a band by pressing the FM/AM
button.
2 Press the
4 or ¢ ( or ) button to
tune in a station.
3 Press the SET button.
“SET” will blink for 5 seconds.
Within 5 seconds, proceed to the next step.
When the display returns to the one set in step 2 after 5
seconds, press the SET button again.
4 Press the > or < button within 5 seconds
to select the preset number.
> or < button: Increase or decrease the preset
number by 1.
Pressing and holding the button
will rapidly increase or decrease
the preset number.
5 Press the SET button within 5 seconds.
“STORED” appears and after 2 seconds, the display re-
turns to the broadcast frequency display.
6 Repeat above steps 1 to 5 for each sta-
tion you want to store in memory with a
preset number.
To change the preset stations, repeat the same
steps as above.
CAUTION:
• Even if the system is unplugged or if the
power failure occurs, the preset stations
will be stored for about 24 hours. However,
in case the preset stations are erased, you
will need to preset the stations again.
SET STORED
SET SET
FM/AM
When changing the
Band
FM = 30, AM = 15
or
VS-DT6-9R(B)_EN.book Page 16 Thursday, January 17, 2002 1:26 PM