Jura Capresso X95 - Manual (Page 15)

15
ECONOMY MODE OFF means that the stand-by-status for steam
is set to 20 minutes and the heating for the cup warming tray is on.
After 10 minutes the warning lamp goes out. By pressing the steam
key anew, the machine returns to stand-by-status for drawing off
steam.
13.9 Programming timer clock
A programming of the timer clock is necessary if an auto-
matic switch on time is required.
Ⅲ TIME —.—
Ⅲ Press key .
Ⅲ By briefly pressing key
or you can set the hours and then
confirm by pressing key .
Ⅲ By briefly pressing key or you can set the minutes and
then confirm by pressing key .
Ⅲ By pressing the button, you can select the next phase, or
press the button in order to leave the programming.
13.10 Programming automatic switch on time
A programming of the timer clock is necessary if an automatic
switch on is needed.
Ⅲ
UNIT ON —.—
Ⅲ Press key .
Ⅲ By briefly pressing key
or you can set the hours and then
confirm by pressing key .
Ⅲ By briefly pressing key or you can set the minutes and
then confirm by pressing key .
Ⅲ By pressing the button, you can select the next phase, or
press the button in order to leave the programming.
N
+
P
- +
P
- +
P
N
+
P
- +
P
- +
P
To switch off the automatic timer proceed as follows:
Press key
Press key
UNIT ON —:—
13.11 Programming automatic switch off time
Ⅲ OFF AFTER 5.0 HOURS
Ⅲ Press key
Ⅲ By briefly pressing key
or you can set the hours and then
confirm by pressing key (0.5 to 9.0 hours).
Ⅲ By pressing the button, you can select the next phase, or
press the button in order to leave the programming.
13.12 Cup counter
Ⅲ 200 SUPPLIED (TOTAL SUPPLIED)
Ⅲ To obtain the information press the required key. The display
will show you the number of times the function has been chosen.
Ⅲ By pressing the button, you can select the next phase, or
press the button in order to leave the programming.
It is not possible to call up hot water and steam supplies.
13.13 Programming language selection
Ⅲ Press key
Ⅲ By briefly pressing key
or call up the language desired
and then confirm by pressing key .
Ⅲ By pressing the button, you can select the next phase, or
press the button in order to leave the programming.
N
+
P
- +
P
N
+
N
+
P
- +
P
N
P
E