Jura Capresso F70 - Manual (Page 9)

9
5. Installation of Claris plus filter cartridges
If the Claris plus filter cartridge is installed properly, de-
scaling of the coffee machine is no longer required. For
more information on the Claris plus filter cartridge refer to
brochure «Claris plus. Hard on limescale. Gentle on your
coffee machine.»
5.1 Installing the filter
Draw off 1/2 litre of water to rinse filter completely. In order
to ensure perfect operation, close tap (14) only after the dis-
play says
CLOSE TAP
Ⅲ Fold up the cartridge holder. Install the filter cartridge in the
water tank, applying a gentle pressure (Fig. 1).
Ⅲ Fold down the cartridge holder again until it engages audibly.
Ⅲ Fill the water tank with cold, fresh tap water and install it again.
Ⅲ Press the Rotary Switch (1) until
FILTER – /
ߛ appears
Ⅲ
FILTER –
Ⅲ Press the Rotary Switch (1) to start the programming.
Ⅲ
NO –
Ⅲ Turn the Rotary Switch (1) until the following message is dis-
played:
Ⅲ
YES
ߛ
Ⅲ Press the Rotary Switch (1) to activate the filter cartridge.
Ⅲ
INSERT
OPEN TAP
Ⅲ Put a sufficiently large container (approx. 1 litre) under the
replaceable hot water nozzle (16).
Ⅲ If not installed already, insert the Claris plus filter.
Ⅲ Open the steam / hot water draw-off tap (14) (Fig.12).
Ⅲ
RINSING
FILTER
Ⅲ CLOSE TAP
Ⅲ Close the steam/hot water draw-off tap (14), now the IM-
PRESSA will heat up to coffee temperature.
Ⅲ HEATING UP
Ⅲ
READY
Now you have activated the filter. In Programming Mode the
water hardness selection function is no longer displayed.
5.2 Replacing the filter
Draw off 1/2 litre of water to rinse filter completely. In order
to ensure perfect operation, close tap (14) only after the dis-
play says
CLOSE TAP
After drawing off approx. 50 litres, the filter cartridge will be
used up. A message requesting you to replace the filter will
appear on the display. The scale on the cartridge holder in
the water tank will tell you how much longer you can use the
CLARIS plus filters.
Ⅲ CHANGE FILTER / MACHINE READY
Ⅲ Touch the
symbol (7).
Ⅲ
REPLACE
OPEN TAP
Ⅲ Remove the water tank from the machine and empty it.
Ⅲ Fold up the cartridge holder. Install the filter cartridge in the
water tank, applying a gentle pressure (Fig. 1).
Ⅲ Fold down the cartridge holder again until it engages audibly.
Ⅲ Fill the water tank with cold, fresh tap water and reinstall it.
E