Jonsered CS 2171WH - Manual (Page 26)

26 – English
FUEL HANDLING
Chain oil
• The chain lubrication system is automatic and we
recommend the use of special oil (chain oil) with good
adhesion characteristics.
• In countries where no special chain oil is available, EP90
transmission oil can be used.
• Never use waste oil. This results in damage to the oil
pump, the bar and the chain.
• It is important to use oil of the right grade (suitable
viscosity range) to suit the air temperature.
• In temperatures below 0 °C (32°F) some oils become too
viscous. This can overload the oil pump and result in
damage to the oil pump components.
• Contact your service agent when choosing chain oil.
Fuelling
Clean the area around the fuel cap. Clean the fuel and chain
oil tanks regularly. The fuel filter must be replaced at least
once a year. Contamination in the tanks causes malfunction.
Make sure the fuel is well mixed by shaking the container
before refuelling. The capacities of the chain oil tank and fuel
tank are carefully matched. You should therefore always fill
the chain oil tank and fuel tank at the same time.
!
WARNING! Taking the following precautions,
will lessen the risk of fire:
Do not smoke or place hot objects near fuel.
Always shut off the engine before refuelling.
When refuelling, open the fuel cap slowly so
that any excess pressure is released gently.
Tighten the fuel cap carefully after refuelling.
Always move the machine away from the
refuelling area before starting.
Min 3 m
(10ft)