JVC SA-K51U - Manual (Page 4)

4 5
How to Attach
First, set the ID of the hard disk drive to “SLAVE.” Refer to the instructions on how to set the
ID shown on the top (side with the model-name label affixed) of the hard disk drive.
1.
Fix the SA-K51U in place by inserting the screws (silver) into the four screw holes of the
stand and tightening them.
SA-K51U
Fix in place so as the
flap and the hard disk
drive’s connectors are
on opposite sides.
Stand
2.
Open the cover of the VR-510U and remove the clamp from the power cable for the hard
disk.
Clamp
Hard disk power cable
3.
Fix the SA-K51U in place by inserting the screws (black) into the four screw holes of the
stand and tightening them while the connector part of the SA-K51U is positioned so that
it is faces the rear panel of the VR-510U.
* Keep the screws straight and steady when tightening them because the stand has
non-threaded screw holes.
Connector part
4.
Connect the hard disk power cable and flat cable to the connectors on the SA-K51U.
Flat cable
Hard disk power cable