JVC TK-C1430 - Manual (Page 27)

E-27
Item Functions and set values Initial value
SHUTTER
/ExDR
* When the SHUTTER (ExDR) item is set to NORMAL, the following items
(SHUTTER SPEED, FAST LIMIT, ExDR LEVEL, and M.ExDR SPEED) cannot
be changed.
SHUTTER
SPEED
NORMAL
1/120
This sets the electronic shutter as well as the ExDR (Extended
Dynamic Range).
The use of an electronic shutter function enables shooting with
proper brightness, as more brightness results in higher shutter
speed.
The ExDR function allows even the shooting of a subject having
different luminous flux density by composing a picture shot at 1/
100 sec. shutter speed with a picture shot by a high-speed
shutter.
NORMAL: This fixes the shutter speed to 1/50.
The ExDR does not function.
MANUAL: This sets the shutter speed by the item SHUTTER
SPEED on the SHUTTER screen.
The ExDR does not function.
When SENSE UP is functioning, MANUAL cannot be
selected. (Not displayed on MENU)
AUTO: This automatically switches the shutter speed
according to brightness.
The ExDR does not function.
The item FAST LIMIT on the SHUTTER (ExDR) screen
sets a maximum shutter speed value.
M.ExDR: This is used when shooting a subject with difference
in a luminous flux density in the screen under a fixed
illumination condition, and so on. During ExDR mode,
the item M.ExDR.SPEED on the SHUTTER (ExDR)
screen sets the composing high shutter speed. It is
possible to set only when the items BLC and SENSE
UP are OFF. What’s more, the ExDR LEVEL sets the
signal level of the composing high-speed shutter.
A.ExDR: This is used when the subjects having different
luminous flux densities are continuously used night
and day in the situation where both indoor and outdoor
subjects are mixed in existence, and so forth. During
ExDR mode, the composing shutter speed
automatically varies according to the contrast of a
subject. This is set when shooting the subject with
changing brightness.
This can be set only when the item BLC is OFF.
What’s more, the ExDR LEVEL sets the signal level
of the composing high-speed shutter.
MEMO
• Do not set to A.ExDR when using a manual lens.
• When M.ExDR mode or A.ExDR mode is used, the border
between a bright part and a dark part can be coloured (cyan,
orange, etc.), but this is not a malfunction.
• When the SHUTTER/ExDR item is set to M.ExDR or
A.ExDR, a flicker can occur under a fluorescent lamp,
mercury lamp, etc. However, this occurs by principle of the
ExDR function, and therefore this is not a malfunction.
This sets a shutter speed when MANUAL is set.
The AUTO, M. ExDR, A. ExDR set value is displayed as
“- - -” and cannot be changed
[Set values: 1/120, 1/250, 1/500, 1/1000, 1/2000, 1/4000, and 1/
10000]
TK-C1430_23-44_E 05.6.20, 10:42 AM 27