John Deere 5310 S - Manual (Page 37)

Operating the Engine
PY80265,05I0120 –19–12SEP05–1/1
Starting the Engine
TS177
–UN–11JAN89
PY4497
–UN–13JAN05
A—Hand Throttle
B—Key Switch On
1. Push hand throttle (A) forward off idle position
(approximately 1/3 of full throttle). Engine may not start
with throttle pulled completely down.
CAUTION: Avoid possible injury or death from a
machine runaway.
Do not start engine by shorting across starter
terminals. Machine will start in gear and move if
normal circuitry is bypassed.
Start engine only from operator’s seat with
transmission in NEUTRAL.
NEVER start engine while standing on ground.
IMPORTANT: DO NOT run a cold engine at full
throttle. Engine should be kept at idling
for 30 sec before the RPM is increased,
this should be strictly followed
otherwise sudden acceleration may
damage the Turbocharger.
2. Depress clutch pedal and turn key switch fully
clockwise (B) to engage starter. Release key when
engine starts. If key is released before engine starts,
wait until starter and engine stop turning before trying
again.
IMPORTANT: DO NOT operate starter more than 20
seconds at a time. If engine does not
start, wait at least two minutes for the
starter motor to cool before trying
again. If engine does not start in four
attempts, refer to “Troubleshooting”
section.
45-2
082206
PN=35