JL Audio Stealthbox SB-GM-CLREXT/10W3v3/DG - Manual (Page 3)

Specifications:
Enclosure Type: Sealed
Driver Type: 10W3v2-D2
Nominal Impedance: 4
Ω
Cont. Power Handling: 300 Watts
JL Audio recommends using a high quality amplifier such as the JL Audio 250/1. The diagram below shows the recommended
crossover, infrasonic filter and equalizer settings for the 250/1 when being used to power your Stealthbox®.
Included Hardware:
4) 1/4” Flat Washer
4) 1/4” Split Lock Washer
2) 1/4”-20 x 1” Bolts
2) #6 x 30mm-1mm Hex Bolts
1) 3/8” Split Lock Washer
2) 3/8” Flat Washer
1) 3/8” Fender Washer
1) 3/8”-16 x 2” Tap Bolt
1) 3/8”-16 Hex Nut
3) 3/4”Lx3/4”ODx3/8”ID Spacers
2) 1”L x1”OD x3/8”ID Spacers
10369 N. Commerce Pkwy, Miramar, Florida 33025-392 Phone: 954.443.1100 Fax: 954.443.1111
JL AUDIO 250/1
monoblock subwoofer amplifier
Amplifier Input Section
Input Sens. Input Voltage
Low/High
Left Ch. Right Ch.
Signal Sensing
Off/On
Output Mode
Full-Range/Low-Pass/High-Pass
Left Ch. Right Ch.
Amp LP Filter
Mode/Slope
Off/12dB/24dB
Filter Freq. (Hz)
Bass Control
LF Boost (dB)
Off/30Hz
Infrasonic Filter
+1 +13
+3
+7
+10
Preamp Output Section +12VDC Ground Remote
The JL Audio 250/1 is a very versatile audio component. Please consult the owner’s manual for detailed information
about installing and tuning this amplifier.
➔ ➔ ➔
STEP 13: Place a supplied 3/4”Lx3/4”ODx3/8”ID
spacer onto the thumb screw.
Insert the thumb screw through the front of the
plastic jack cover.
STEP 14: On the back side of the plastic jack
cover.
Place the remaining pair of 3/4”Lx3/4”OD,3/8”ID
spacers onto the thumb screw.
STEP 15: Place the tire stops and jack back onto
the jack bracket.
Place the plastic jack cover over the jack assembly
and secure with the thumb screw.
➔
S B - G M - C L R E X T / 1 0 W 3 v 2 , J L AU D I O, I n c 2 0 0 5 S h e e t S K U # 0 1 1 1 9 5 R ev i s i o n 5 / 1 9 / 2 0 0 5 Pa g e 3 w w w . j l a u d i o . c o m
Mid/High Frequency Driver Information:
CONGRATULATIONS!
INSTALL COMPLETE.
XR650-CSi
TR650-CXi
Front Location Driver Size:
6.5”
Applicable JL Audio Products:
TR,VR,XR & ZR650-CSi
Rear Location Driver Size:
6.5”
Applicable JL Audio Products:
TR,VT & XR650-CXi
Cont.
From
Previous
Page
Difficulty Of Installation: