JBL ON Stage Micro II - Manual (Page 5)

5
troubleshooting your jbl on stage micro II
Symptom Possible Problem Solution
If you have any questions or need further assistance, please visit www.jbl.com.
These specifications are subject to change without notice.
No sound from the
JBL On Stage Micro II
speaker system
Technical Specifications
Frequency Response:
70Hz – 20kHz
Power Consumption:
10W Maximum
Power Input:
6V/1.5A
JBL On Stage Micro II Transducer:
(2) 1 " Full range per channel
Dimensions:
Diameter – 6 " (150mm)
Height – 1-3/4 " (38mm)
System Weight:
2.22 lb (1.01kg)
Battery:
Size – AAA
Type – Alkaline, NiMh
Quantity – 4
DO NOT MIX BATTERY TYPES.
DO NOT MIX CHARGED AND
PARTIALLY CHARGED BATTERIES.
BATTERIES WILL NOT RECHARGE
WHILE IN JBL ON STAGE MICRO II.
Ensure that the power supply is connected to a live
power source and properly connected to the JBL On
Stage Micro II. Note: When the JBL On Stage Micro II
is powered, a green power LED on the JBL On Stage
Micro II should light up.
Touch the volume “Up” (+) pad on the volume
control to unmute and/or increase the system volume
level.
Note: Touching the volume “Down” (–) pad lowers
the system volume. Touching both the (+) and (–)
volume control pads at the same time will mute the
system.
Increase the volume level on the audio source device.
Replace the batteries.
Press the Play button on the iPhone/iPod or remote
control.
Note: If the iPhone/iPod is paused more than 10 min-
utes, press the JBL On Stage Micro II Power button to
turn the unit back on. Press either (+) or (–)
to unmute.
No power to the system
Power adapter plug is not
inserted correctly
No volume or low volume
Input source is low
Low or drained batteries
iPhone/iPod is paused
iPhone/iPod is paused
(battery-only mode)
Troubleshooting