JVC TH-A32 - Manual (Page 51)

49
Using Preset Tuning
Once a station is assigned to a channel number, the station can be
quickly tuned. You can preset up to 30 FM and 15 AM stations.
To store the preset stations automatically
From the remote control ONLY:
Press and hold MEMORY for a while.
“AUTO SAVE” appears on the display, and automatic
preset starts.
Local stations with the strong signals are searched for and stored
automatically in the band. When FM preset is over, the band
changes to AM and automatic preset starts.
To store the preset stations
From the remote control ONLY:
1
Tune in the station you want to preset (see
“Tuning in Stations”).
2
Press MEMORY.
“SAVE TO” appears on the display.
3
Press the number button to
select a preset number.
• To select number 1 to 9, press the
corresponding number button.
• To select number 15, press 1, 5.
• To cancel a mis-entry, press CLEAR.
4
Press ENTER to store the
preset station.
“SAVED” appears on the display and the
station is assigned to the selected preset
number.
5
Repeat steps 1 to 4 until you store all the stations
you want.
To erase a stored preset station
Storing a new station on a used number erases the previously stored
one.
To tune in a preset station
From the remote control ONLY:
1
Press FM/AM repeatedly to select the
band.
The last received station of the selected band is
tuned in.
• Each time you press the button, the band alternates between
FM and AM.
2
Press the number button to
select a preset station.
• To select number 1 to 9, press the
corresponding number button, then
press ENTER.
• To select number 15, press 1, 5 then press ENTER.
• To cancel a mis-entry, press CLEAR.
• You can press ¡/1 to select the preset station.
¡: Increases the preset number.
1: Decreases the preset number.
Selecting the FM Reception Mode
When an stereo FM program tuned currently is noisy, you can
change the FM reception mode to improve the reception.
From the remote control ONLY:
Press FM MODE.
The STEREO indicator goes off from the display and
the program loses the stereo effect.
To resume the stereo effect, press FM MODE again.
The stereo effect resumes.
Note:
The FM reception mode will also resumes in the following cases:
• When you change the frequency, the preset number, or the band
• When you change the source (If you use SOURCE button on the
unit, the FM reception mode is memoried.)
• When you turn off the system
MHz
TUNED
STEREO
R L
REC/MEMORY
TUNED
STEREO
R L
REAR-R REAR-L
TEST CLEAR SETTING
1 2 3 4
5 6 7 8
9 0
CENTER SUBWOOFER
ENTER
REC/MEMORY
FM/AM
FM MODE
FM MODE
REAR-R REAR-L
TEST CLEAR SETTING
1 2 3 4
5 6 7 8
9 0
CENTER SUBWOOFER
EN48-49TH-A35[J].pm6 03.2.3, 4:04 PM 49