JVC DR-MH30S - Manual (Page 19)

Masterpage:Right+
EN
19
Filename [DR-MH30EU_04Name.fm]
INITIAL SETTINGS
Page 19 Tuesday, 1 June 2004 17:38
Auto Channel Set by Downloading from TV/Auto Clock
Set/Auto Guide Program Number Set
If you have connected the unit to your TV via a 21-pin SCART
cable (
੬ pg. 17), the unit will automatically perform Preset
Download instead of the Auto Set Up in step 4 on page 18. After
downloading, the unit sets the clock and Guide Program numbers
automatically.
1
Press w e to select “T-V LINK”
and press ENTER. The T-V LINK
screen will appear.
ATTENTION:
Preset positions on the front display
panel increase from “PR 1”; do NOT
press any button on the unit or remote
control until the front display panel
shows clock time, “PR 1” or “– –:– –”
as illustrated on page 20.
● When Preset Download is
completed, “COMPLETED”
appears for about 5 seconds, then
the normal screen appears.
● If you press any button on the unit
or remote control while
downloading is in progress, it will
be interrupted.
NOTES:
● For details, refer to the instruction manual of your TV.
● In the area where no TV station transmits a PDC (Programme
Delivery Control) signal, the unit can perform neither Auto Clock Set
nor Auto Guide Program Number Set.
● If there is a power cut, or if you press 1 or SET UP while
downloading or set up is in progress, it will be interrupted; be sure to
turn off the unit power once and try again from the beginning.
● Auto Clock Set may not function properly depending on the reception
condition.
● On this unit, the characters available for station names (ID) are A–Z,
0–9, –, f , + and I (space). Some names of downloaded stations
may differ from those of your TV. (
੬ pg. 72)
Preset Download
ATTENTION:
You can use this function only with a TV offering T-V Link, etc.* Be
sure to use a fully-wired 21-pin SCART cable.
* Compatible with TVs offering T-V Link, EasyLink, Megalogic,
SMARTLINK, Q-Link or DATA LOGIC via a fully-wired 21-pin SCART
cable. The degree of compatibility and available functions may differ by
system.
we
ENTER
CABLE/DBS
DVD TV
● Slide the TV/CABLE/SAT/DVD switch to DVD.
● Perform steps 1 to 3 of “Auto Set Up” ( ੬ pg. 18) before continuing.
After “Preset Download” is completed, perform “Monitor Set” on
page 22.
PRESS [SET UP] TO EXIT
ENTER
SELECT EXIT
SET UP SELECT WITH [ ] THEN PRESS [ENTER]
INITIAL SET UP > AUTO CH SET
TEST MODE
AUTO SET T-V LINK
PRESS [SET UP] TO EXIT
ENTER
SELECT EXIT
SET UP SELECT WITH [ ] THEN PRESS [ENTER]
INITIAL SET UP > AUTO SET
AUTO SET
PLEASE WAIT...
DR-MH30EU_04Name.fm Page 19 Tuesday, June 1, 2004 5:38 PM