JVC HR-J670EK - Manual (Page 5)

5
ENTREE
ANT. IN
ENTREE/DECODEUR
IN/DECODER AV2 ENTREE/SORTIE
IN/OUT
SORTIE
RF OUT
ANTENNE AV1
SORTIE
OUT
R
L
AUDIO
CONTROLEUR SAT
SAT CONTROL
( L-1 ) ( L-2 )
AV CONNECTION
To connect to a TV with 21-pin AV input connector (SCART) . . .
1– Connect the aerial, recorder and TV as per “RF CONNECTION”.
2– Connect an optional SCART cable between the AV1 (L-1)
IN/OUT socket on the rear panel of the recorder and the TV’s
21-pin AV input connector (SCART).
STEP
2 INSTALLATION
CONNECT VIDEO RECORDER TO TV
Place the recorder on a stable, flat surface.
Make this connection
if your TV has a 21-pin
AV input connector
(SCART) in order to reduce
the possibility of interference.
And if you are using a stereo
TV, you will need this cable
in order to enjoy stereo
playback of videotapes.
RF CONNECTION
To connect to a TV with NO 21-pin AV input connector
(SCART) . . .
1– Disconnect the TV aerial cable from the TV.
2– Connect the TV aerial cable to the ANT. IN jack on the rear
panel of the recorder.
3– Connect the provided RF cable between the RF OUT jack on
the rear panel of the recorder and the TV’s aerial connector.
ATTENTION
Ⅲ Do NOT Plug the mains power cord into a mains outlet until all connections are completed.
Ⅲ Do NOT press the button on the recorder or on the remote control to turn on the recorder's
power before you start the Auto Set Up procedure described on page 6.
21-pin AV input connector
(SCART)
Aerial connector
Back of TV
21-pin SCART Cable (not provided)
RF Cable (provided)
TV Aerial Cable
(not provided)
Mains Power Cord
Back of Recorder
Mains outlet
Go to Step 3 – AUTO SET UP AFTER YOU FINISH THIS STEP