JVC CA-MXG50 - Manual (Page 19)

– 14 –
English
CD playback sequence (when ALL DISC is selected)
When 3 CDs are loaded on the disc trays, they are played in one of
the following sequences.
• When CD1 is pressed : CD1
] CD2 ] CD3 (then stops)
• When CD2 is pressed : CD2 ] CD3 ] CD1 (then stops)
• When CD3 is pressed : CD3 ] CD1 ] CD2 (then stops)
* When only 2 CDs are loaded, they are played in the same order,
but the disc tray without a CD is skipped.
Basic CD Operations
While playing a CD, you can do the following operations.
To exchange CDs during playback of another
Press DISC CHANGE to change the CD and the
carrousel comes out.
If you change CDs during play, the current play
will not stop until all CDs you have changed are
played.
To close the carrousel, press DISC CHANGE or
0.
To skip to the another CD in the carrousel
Press DISC SKIP on the remote control.
To stop play for a moment
Press CD 6.
While pausing, “PAUSE” appears on the
display.
To resume play, press CD 6 again.
To locate a particular point in a track
During play, press and hold 1 or ¡.
•
1: Fast reverses the disc.
•
¡: Fast forwards the disc.
When using the remote control, press and
hold
4 or ¢.
To go to another track
Press
4 or ¢ repeatedly before or
during playback.
•
4: Goes back to the beginning of the
current or previous tracks.
•
¢: Skips to the beginning of the next or
succeeding tracks.
If you press and hold 4 or ¢ on the unit before or
during play
You can change the tracks continuously.
To go to another track directly using the number buttons
Pressing the number button(s) before or
during play allows you to start playing the
track number you want.
Ex.: For track number 5, press 5.
For track number 15, press +10, then 5.
For track number 20, press +10, then 10.
For track number 32, press +10, +10, +10, then 2.
Programming the Playing Order of the Tracks
— Program Play
You can arrange the order in which the tracks play before you
start playing. You can program up to 32 tracks.
• To use Repeat play (see page 15) for Program play, press
REPEAT after starting Program play.
On the unit ONLY:
1
Load CDs.
• If the current playing source is not the CD player, press
CD
6, then 7 before going to the next step.
2
Press PROGRAM so that
“PROGRAM” appears on the
display.
The PRGM (program) indicator also lights up on the
display.
• If a program has been stored in memory, the program is
called up.
3
Press one of the disc number
buttons (CD1, CD2 or CD3)
to select the disc number you
want to play.
4
Press
4 or ¢ to select the track number,
then press SET.
Each time you select a track and press SET, the selected
track number is added to the CD track number indicator.
Track number
TUNING
PRESET
1 2 3
4 5 6
7 8 9
10 +10
PRESET
PROGRAM RANDOM EAT
DISC CHANGE
Disc number Program step number
SET
DISC SKIP
Continued
EN13-16.CA-MXG50[UW]_f 01.4.3, 2:17 PM 14