John Lewis JLBIOS664 - Manual (Page 27)

27
How to use the pyrolytic cleaning
function
Before activating the pyrolytic cleaning
function, remove any excessive spillage
and make sure that the oven is empty. Do
not leave anything inside it (e.g. pans,
grids, baking tray, dripping pan, etc.) as
this could heavily damage them.
Ensure that the oven door is closed before
activating the pyrolytic cleaning function.
When the pyrolytic cleaning function is on,
it is advisable not to use the hob as this
could cause overheating and damage the
appliance.
During the pyrolytic cleaning cycle the
oven door becomes hot. Children should
be kept away until it has cooled.
If the oven has been installed under a built-
in hob, do not switch the hob cooking zones
on while pyroliytic cleaning is running.
Choose this function to clean the oven by pyrolysis.
The following pyro levels are available:
Pyrolytic 1 (P I) time : 2 h = 30 min heat-up +1 h
at 480°C + 30 min cooling down.
Pyrolytic 2 (P 2) time : 2 h 30 min. = 30 min heat-
up +1 h 30 min at 480°C + 30 min cooling down.
The pyro duration time cannot be changed.
To activate the pyrolytic cleaning function proceed
as follows:
1. Press button to switch on the oven. Press
the Oven function button as often as
necessary, until the “Pyro“ function symbol
(level 1 - P I) will appear in the display.
Simultaneously, the symbol and the
“P I” writing will flash in the display and an
acoustic signal will be emitted.