JVC LVT1148-010A - Manual (Page 42)

39
Tuner operations
IMPORTANT
Before using the remote control for the
following operation;
1 Set the remote control mode selector to
AUDIO.
2 Press FM/AM.
Some countries space AM stations 9 kHz apart, and other countries
use 10 kHz spacing.
• 9 kHz interval spacing is the initial setting.
On the center unit ONLY:
7 When AM is selected as the source
To select the 10 kHz interval
Press and hold 7, then press 8. “10k STEP” appears on the display
window.
To select the 9 kHz interval
Press and hold 7, then press 3. “9k STEP” appears on the display
window.
1
Press FM/AM repeatedly to select the
band.
Example:
When the system is tuned in to 810 kHz.
2
Press TUNING 9/( repeatedly until
you find the frequency you want.
When you hold down the button until the system starts
searching for stations and then release it, the system stops
searching automatically when a station of sufficient signal
strength is tuned in to.
NOTE
• When a station of sufficient signal strength is tuned in, the TUNED
indicator lights on the display window.
• When an FM stereo program is received, the ST indicator lights on the
display window.
The buttons described below are used on pages 39 to 40.
Number buttons
Remote control
mode selector
Setting the AM tuner
interval spacing
Manual tuning
VOLUME STANDBY
PHONES
8 1 0 k
TH-S8S5[USUB].book Page 39 Friday, May 28, 2004 2:22 PM