John Lewis GAS HOB JLBIGGH605 - Manual (Page 21)

21
occasionally leaves rough edges. If
necessary, remove stubborn stains
using a paste cleaner.
After cleaning, make sure that the pan
supports are correctly positioned.
To keep the pan supports in the correct
position, they are mounted on metal pins
located in the lateral sides of the hob. To
ensure a better cleaning, pan supports can be
removed from the hob. Lift up the pan
suports keeping them in horizontal position
as shown in figure 2.
Avoid lifting the pan supports at Avoid lifting the pan supports at Avoid lifting the pan supports at Avoid lifting the pan supports at Avoid lifting the pan supports at
an angle, as this will put strain
an angle, as this will put strain an angle, as this will put strain an angle, as this will put strain an angle, as this will put strain
on the metal pins. This may
on the metal pins. This may on the metal pins. This may on the metal pins. This may on the metal pins. This may
damage the pins and cause them
damage the pins and cause them damage the pins and cause them damage the pins and cause them damage the pins and cause them
to break.
to break. to break. to break. to break.
Pa Pa Pa Pa Pay attention when r y attention when r y attention when r y attention when r y attention when replacing the eplacing the eplacing the eplacing the eplacing the
pan supports in order to avoid pan supports in order to avoid pan supports in order to avoid pan supports in order to avoid pan supports in order to avoid
in order to avoid scratching the
in order to avoid scratching the in order to avoid scratching the in order to avoid scratching the in order to avoid scratching the
glass hob top.
glass hob top. glass hob top. glass hob top. glass hob top.
The Burners The Burners The Burners The Burners The Burners
The burner caps and crowns can be removed
for cleaning.
Wash the burners caps and crowns using hot
soapy water, and remove marks with a mild
paste cleaner. A well moistened soap
impregnated steel wool pad can be used with
caution, if the marks are particularly difficult
to remove.
After cleaning, be sure to wipe dry with a soft
cloth.
The Ignition electrode The Ignition electrode The Ignition electrode The Ignition electrode The Ignition electrode
The electric ignition is obtained through a
ceramic electrode which contains a metal
electrode (Fig. 1 - C
C C C C). Keep these
components very clean, to avoid difficult
lighting, and check that the burner crown
holes (Fig. 1 - B
B B B B) are not obstructed.
NO
YES
Fig. 2 Fig. 2 Fig. 2 Fig. 2 Fig. 2