JVC CU-VD3U - Manual (Page 15)

EN
FR
ES
15
Troubleshooting
Trouble Action
CU-VD3
Cannot turn the power
on. z Make sure the AC adapter and power cord are connected
properly.
The burner and AC
adapter is hot.
z This is not a malfunction.
z If the burner is abnormally hot, remove the AC adapter and
consult your authorized dealer.
Cannot open the disc
tray.
z A disc cannot be ejected by pressing the eject button if data
is being written to the disc. Wait until writing finishes.
z If a disc cannot be ejected with the eject button:
• Remove and insert the AC adapter, then press the eject
button again.
• If the disc cannot be ejected using the above method,
remove the AC adapter and all other connections. Insert a
thin rod of about 5 cm into the force eject hole located on
the right side of the eject button. The disc tray will be
ejected for about 1 cm, pull out the disc tray manually and
take out the disc.
Reading fails.
z Insert the disc with the label facing up.
z Make sure the disc tray is not dirty.
z Make sure the writing surface of the disc is not damaged.
z Make sure the special-shaped discs are not used.
z Make sure the audio CD complies with the CD-DA standard.
(Copy-control CDs cannot be played.)
z For CD-R or CD-RW, make sure it is not recorded using the
packet-write method.
Writing fails.
z Make sure an appropriate disc is being used. (A P. 4, 17)
z Use discs recommended for the burner. (A P. 4, 17)
z Make sure that a new disc is used for DVD-R.
z Insert the disc with the label facing up.
z Make sure the disc tray is not dirty.
z Make sure the writing surface of the disc is not damaged.
z Make sure the special-shaped discs are not used.
The writing time is too
long.
z The time taken for writing may be longer depending on the
usage environment and conditions of usage. This is not a
malfunction. It is the performance of this burner.
CU-VD3U_001C_EN.book Page 15 Monday, December 10, 2007 10:40 AM