JVC HR-XVC39SU - Manual (Page 11)

Rear of DVD+VCR
L R
AUDIO INPUT VIDEO INPUT
ANTENNA
INPUT
Rear of TV
A1 V R
Y Pb Pr
COMPONENT/PROGRESSIVE SCAN
VIDEO INPUT
L R
AUDIO INPUT S-VIDEO
INPUT
Rear of TV
S A2 C
Optional TV Connections
These connections support only DVD playback. The
tuner and VCR still output through the RF.OUT
(R) or
DVD/VCR OUT (A, V) jacks.
Audio connection
Connect the Left and Right AUDIO OUT jacks of the
DVD+VCR to the audio left/right in jacks on the TV
using an optional audio cable
(A2).
S-Video connection
Connect the S-VIDEO OUT jack on the DVD+VCR to
the S-Video in jack on the TV using the optional
S-Video cable
(S).
Note:
For S-Video connection, resolution must be set to
480i or 480p, however S-VIDEO OUT is always at
480i standard resolution.
Component Video / Progressive Scan
connection
If your television is a high-definition or “digital
ready” television, you may take advantage of the
DVD+VCR’s progressive scan output for the highest
video resolution possible.
Connect the COMPONENT/PROGRESSIVE SCAN
VIDEO OUT jacks on the DVD+VCR to the corre-
sponding in jacks on the TV using an optional Y Pb
Pr cable
(C).
Notes:
The 480p and 720p resolutions are Progressive
scan applied resolutions.
Progressive scan does not work with the analog
video connections (yellow VIDEO OUT jack and
S-VIDEO OUT jack).
Resolution Setting
The resolution setting support only DVD playback.
Before you set the resolution, this unit must be in
stop mode. Press STOP (x) to stop playback.
Press OUTPUT STATUS on the front panel once.
The current resolution setting will be appears in
the display window.
Press OUTPUT STATUS repeatedly to change the
resolution you want.
The available resolution according to the connections
are as shown below.
OUTPUT
CONNECTIONS
Available
Resolutions
HDMI
VIDEO OUT
1920 x 1080i
1280 x 720p
720 x 480p
COMPONENT
VIDEO OUT
1920 x 1080i
1280 x 720p
720 x 480p
720 x 480i
VIDEO OUT 720 x 480i
S-VIDEO 720 x 480i
Notes:
For 720p and 1080i resolution on the component
video out, only non-copy protected discs can be
played back. If the disc is copy protected, it will
be displayed in the 480p resolution without HDMI
cable connection. With HDMI cable connection, the
picture may not be displayed properly.
If your TV does not support the resolution you have
set, the picture may not be displayed properly.
Please read TV’s owner’s manual then set the reso-
lution that your TV can accept.
•
•
1.
2.
3.
•
•
11
Preparation