Jura Capresso Impressa F7 - Manual (Page 22)

5. The displays still shows SOLVENT IN TANK / OPEN TAP .
Turn the Steam/Water Selector to the water symbol. The
machine will pump the mixture through the frother in intervals.
During this procedure the display shows
DECALC.ON . When
this cycle is finished the display shows CLOSE TAP .
6. Turn the Steam/Water Selector back to the cup symbol.
The display shows DECALC.ON . Now the machine pumps
the mixture through the coffee spout into the drawer.
7. When this cycle is completed the display shows EMPTY
TRAY . Remove the container from underneath the
frother. Carefully lift and remove the drawer, empty and
thoroughly rinse all parts and replace. The display shows
FILL WATER .
8. Remove the water tank, rinse thoroughly, fill with cold fresh
water and replace.
9. Place a large container (at least 20 oz.) underneath the
frother. The display shows OPEN TAP .
10. Turn the Steam/Water Selector to the water symbol.
The machine will pump hot water through the frother in
intervals. During this procedure the display shows
DECALC.ON .
When this cycle is finished the display shows CLOSE TAP .
11. Turn the Steam/Water Selector back to the cup symbol.
The display shows DECALC.ON . Now the machine pumps
hot water through the coffee spout into the drawer.
12. When the cleaning cycle is completed the display shows
EMPTY TRAY . Remove the container from underneath
the frother. Carefully lift and remove the drawer, empty and
thoroughly rinse all parts and replace. The display shows
HEATING and then PRESS RINSE .
13. Push the Rinse Button. The machine will run a regular rinse
cycle and the display will show READY .
14. Clean front of machine and grid with a moist, soft cloth.
Attention: You can run a decalcifying cycle at anytime even if
the machine does not prompt you.
• Turn the machine off. Push and hold the Rinse button until
display shows EMPTY TRAY .
• Continue with step 2 above.
21. TIPS FOR BETTER COFFEE
Height adjustable coffee-spout
Adjust the height of the coffee-spout to the size of your cups.
Grinding
Please refer to chapter 8 "Adjusting the Grinder."
Pre-warm cups
You should warm cups in advance with hot water or steam.
The smaller the quantity of coffee, the more important it is to
warm your cups.
Sugar and cream
Warmth is lost by stirring the contents of the cup. Adding milk or
cream from the refrigerator considerably lowers the temperature
of the coffee. You can preheat milk and cream with the frother.
22. SUPPLIES AND ACCESSORIES
The following supplies are necessary to keep your machine in
good working order:
• Clearyl Water Filter Cartridge (model# 64533)
• Special Cleaning Tablets (model# 62205)
• Decalcifying Tablets (white, square) model# 61848
Please note: You must use decalcifying tablets if you do not use
the Clearyl cartridge.
22.