Jonsered GT2123 - Manual (Page 9)

English – 9
ASSEMBLY
Fitting the main body
Connect the engine (A) to the tube (B) with four screws (C).
Connecting throttle cable and stop
switch wires
1 Fit the plastic tube (B) around the throttle cable and stop
switch wires as shown.
2 Insert the throttle cable through the cable adjuster sleeve
on the carburettor bracket. Make sure the end of the
throttle cable housing is seated positively in the sleeve.
3 Position the slotted fitting on the carburettor so the
recessed hole (A) is away from the cable adjuster sleeve.
4 Rotate the carburettor throttle cam and slip the throttle
cable through the slot in the slotted fitting, making sure the
cable lug drops into the recessed hole.
5 Press the throttle trigger a few times to check that it works.
6 Connect the stop switch wires to the wires from the engine
(it is not important which wire is connected to which).
Adjusting the throttle wire
1 Loosen the lock-nut (C) and adjust the cable adjuster
sleeve (D) so the stop on the carburettor throttle cam just
contacts the throttle stop and the cable position keep 1–2
mm play between cable lug and slotted fitting when the
throttle trigger is fully depressed.
2 When the throttle cable is adjusted correctly, tighten the
locking nut (C).
Fitting the handle
1 Place the rubber sleeve A on the shaft B.
2 Position the handle as shown. Fit the mounting
components and tighten the handle lightly. Note that the
handle must be mounted below the arrow on the shaft.
3 Now make a final adjustment to give yourself a
comfortable working position. Tighten the screws.
A
B
C
1-2mm
A
B