JVC DLA FS-X3 - Manual (Page 9)

7
Getting Started
Connecting the Speakers (SP-FSX3)
These speakers are exclusively for this system. Using with other devices will damage the speakers.
Connect the speaker cords between the speaker terminals of the Unit and those of the Speakers.
• When inserting the speaker wire lead, open the speaker terminal.
• Connect the black cord to the ( - ) terminal and the cord without a black line to the (+) terminal.
• Since both speakers are the same, you can put either one to the right or left side.
• Do not connect other speakers to the Unit. The difference of the load impedance causes failures.
• Do not use the supplied speakers in parallel with other speakers.
CAUTION:
• A TV may display irregular colors if located near the speakers. If this happens, set the speak-
ers away from the TV.
Connecting a Powered Subwoofer
Connect a signal cord (not supplied) between the System’s SUBWOOFER terminal and the input terminal of an external sub-
woofer. (For the details of connection, please refer to the user’s manual of the external equipment.)
Right side (rear view) Left side (rear view)
BLACK
BLACK BLACK
BLACK
SPEAKER terminal description
(on the side panel)
Signal cord (not supplied)
Subwoofer (not supplied)
FS-X3(A)_E.book Page 7 Friday, March 28, 2003 2:57 PM