JVC HR-XVC41S - Manual (Page 11)

11
Preparation
How to set the DVD+VCR’s RF output channel
1. When the DVD+VCR is turned off, press and hold
CH (+/-) on the front panel for more than five sec-
onds. “RF03” or “RF04” appears in the display
window.
2. Press CH (+/-) to change the RF output channel
(RF03 or RF04). Tune the TV to this channel.
3. Turn off the DVD+VCR.
Audio/Video connection
1. Connect the DVD/VCR VIDEO OUT jack on the
DVD+VCR to the video in jack on the TV using
the video cable supplied (V).
2. Connect the Left and Right DVD/VCR AUDIO
OUT jacks on the DVD+VCR to the audio left/right
in jacks on the TV (A1) using the supplied audio
cables.
Note:
If you use this connection, set the TV’s source selec-
tor to VIDEO.
Optional TV Connections Optional TV Connections
These connections support only DVD playback. The
tuner and VCR still output through the RF.OUT (R) or
DVD/VCR OUT (A, V) jacks.
S-Video connection
Connect the S-VIDEO OUT jack on the DVD Player
to the S-Video in jack on the TV using the S-Video
cable (S).
Component Video / Progressive Scan
connection
If your television is a high-definition or “digital ready”
television, you may take advantage of the
DVD+VCR’s progressive scan output for the highest
video resolution possible.
Connect the COMPONENT/PROGRESSIVE SCAN
VIDEO OUT jacks on the DVD+VCR to the corre-
sponding in jacks on the TV using an optional Y Pb
Pr cable (C).
Notes:
• Progressive scan does not work with the analog
video connections (yellow VIDEO OUT jack and
S-VIDEO OUT jack).
• When you use Component Video signal, set the
Progressive Scan to “Off” on the setup menu.
• If your TV does not accept the Progressive Scan
format, the picture will appear scrambled.
Audio connection
Connect the Left and Right AUDIO OUT jacks of the
DVD+VCR to the audio left/right in jacks on the TV
using the supplied audio cables (A2).