Main outputs l and r, Main level controls, Main compressor controls – SIGMA KAMESAN KS-342 User Manual

Page 10: Sub output, Right side (viewed from front), Ks-342

Advertising

KS-342

The routing switch sends the aux signal to the L and R main out-

put busses (AUX MIX) or to the monitor bus only (AUX MONI) or

completely off (center position).

Right side (viewed from front)

This section is chiefly the outputs from the mixer:

��

�

��

� �

��

�

��

��

�

��

�

��

��

��

��
��

��

�

�
�

��

MAIN outputs L and R

Balanced XLR-3 connectors providing

the main analog output signals from the KS-342. They can also

be used to provide the outputs from input channels 1 and 2, for
example when these are used in MS mode.

MAIN level controls

Use these rotary controls to adjust the

level of the signals sent from the main outputs.

MAIN compressor controls

The main output busses can

be compressed using the onboard compressor (this applies

to all outputs fed by the output busses. The triggering of
the compressor can be done by either the L or the R bus, or

ST LINK setting, in which either bus can be above the trigger
level, or L•R in which both busses must be above the trigger
level (the off position is represented by the • symbol). The

trigger level itself can be set to +3 dB (3), +6 dB (6), +9 dB (9)

or +12 dB (12).

SUB output

This XLR-5 connector provides the main output

busses as balanced sub outputs (or this connector can also be

Advertising

Popular Brands

Popular manuals