Sony SNYSC1 - Manual (Page 15)

[
Installation
] 1
Wiring the SNYSC1 Interface
Power harness
Connect the yellow wire of the power harness to a suitable +12V power source in the
vehicle, which is capable of providing 1 amp of power. Connect the black wire to the
vehicle ground. (Figure 5)
The power harness for the SNYSC1 has power filter box which contains a fuse for the
12V battery connection. Figure 5 also shows the location and type of fuse, and also
the identifies the pin-outs of the power connector.
BATTERY Power Filter
with Fuse
2A AGC Type Fuse
Battery 12 VDC No Connection
GND No Connection
Power Connector
(As Viewed From the Wire End of the Plug)
BATT (Yellow)
GND
(Black)
figure 5 figure 5