Speciþ cations, Standard edition), 20 ampliþ er output – Sunfire True Subwoofer Signature and Standard Version User Manual

Page 20: High cut filter, Frequency response, Power line voltage, Dimensions, Weight, Finish, Line power consumption

Advertising
background image

User's Manual

20

AmpliÞ er Output

2,700 watts rms (3.3

Ω impedance)

High Cut Filter

35 Hz - 100 Hz adjustable, with a "By-
pass" position.

Frequency Response

18 Hz - 100 Hz

Power Line Voltage

US model

120 VAC 50/60 Hz

International model

230 VAC 50/60 Hz

Dimensions

11" x 11" x 11"

Weight

48 lbs

Finish

High gloss, dark rosewood Þ nish.

Line Power Consumption:

600 watts average, at maximum continu-
ous output. 8 watts at idle.
2,700 watts peak, time limited basis

Output Levels:

Greater than 110 dB peak SPL (includes
room gain) from 18 Hz to 80 Hz. Mea-
surement is one meter, anechoic.
A typical SunÞ re subwoofer can be
ex pect ed to ‘best’ its spec i Þ ed minimum
peak SPL by several decibels.

Total Harmonic Distortion

Typically less than 1/10 of the fun da -
men tal between 18 to 80 Hz.

Input Sensitivity (full output):

250 mVrms from left input with volume
control at 0 dB, 60 mVrms volume con-
trol fully clockwise

*

0.75 Vrms from right input with volume
control at 0 dB, 200 mVrms volume
control fully clockwise

*

Input Impedance:

30 k

Ω for Line-Level inputs

56 k

Ω for Hi-Level inputs

40 k

Ω for XLR input, each leg balanced

to ground

XLR Input

Pin 1 Ground
Pin 2 Positive
Pin 3 Negative

Driver: 10 inch

Extra large magnet and long throw
me chan i cal design yield very high
back-emf. The result is ex traor di nar i ly
high operating efÞ ciency – that is, more
acoustic output for each watt of input.

Internal System Gain:

50 dB from left input jack to speaker
with volume control at 0 dB, 62 dB with
control fully clockwise

*

40 dB from right input jack to speaker
with volume control at 0 dB, 52 dB with
control fully clockwise

*

*

The SunÞ re True Sub woof er utilizes
differential gain on the left and right
inputs to retain both L+R and L-R
information.

12 VDC Trigger Input

Input voltage range: 5 -18 VDC
Impedance: approx 600 Ω
(20 mA @ 12 V)
Removable terminal block, and one 1/8”
Mono minijack, tip positive.

SpeciÞ cations

(Standard Edition)

© 2004 SunÞ re Corporation.

All rights reserved. SunÞ re Corporation
re serves the right to improve its products
at any time. Therefore, speciÞ cations are
subject to change without notice.

Manual 913-103-00 Rev B

Advertising