SPT SD-40E - Manual (Page 6)

5
OPERATING INSTRUCTIONS
Operating Conditions:

This unit is designed to operate with a working environment between 41 ~ 95

F.

If the unit has been switched off, please wait 3 minutes before switching on again. If
switched on immediately, allow 3 minutes for unit to resume correct operation.

Do not connect unit to a multiple socket outlet with other electrical appliances.

Select a suitable location, with easy access to an electrical outlet.

Plug the unit into an 115V~ 60Hz electrical socket with earth connection.

Make sure the water tank is correctly fitted or unit will not operate.
Turning the unit ON or OFF:
1.
Plug the cord to a proper power requirement. The unit’s computer system will have a self-
check. If normal, POWER indicator will flash at 0.5Hz. Press the POWER button to start
operation. Unit will begin to operate at 60% humidity setting, press + or
– to change humidity
setting.
2. Press CONTINUOUS button to run in continuous dehumidifying mode. In continuous mode,
+ or – buttons are disabled.
3. Press POWER button again to turn off unit. You do not need to unplug the cord except when
unit will not be used for a long period of time.
OPERATION
Water Tank:

When water tank is full, unit will stop operating and FULL indicator light will flash.

Never remove the water tank while unit is in operation.

Grip the left and right handles securely and carefully pull straight out. Do not place tank on
the floor, as the bottom of the tank is not even and will tilt. Empty the water and gently push
the tank all the way in. Ensure the tank is correctly positioned.

The unit will re-start when the tank is restored in its correct position.